A scanning tunneling microscope (STM) has been developed that can image individual atoms on a surface at least 100 times faster than a traditional instrument. It may also allow researchers to precisely measure the temperatures of single atoms and detect movement over a distance 30,000 times smaller than the diameter of an atom.Cornell University associate professor of physics Keith Schwab and colleagues at Cornell and Boston University used an existing technique in a novel way to develop the new microscope. The simple adaptation, based on a method of measurement currently used in nanoelectronics, could also give STMs significant new capabilities. It offers the potential for atomic resolution thermometry -- the ability to sense temperatures in spots as small as a single atom -- and to detect changes in position as tiny as 0.00000000000001 meters. Cornell associate physics professor Keith Schwab works on a low-temperature apparatus similar to the one he and colleagues used to make the traditionally painfully slow scanning tunneling microscope (STM) operate at least 100 times faster. (Image courtesy Cornell University) The STM uses quantum tunneling, or the ability of electrons to "tunnel" across a barrier, to detect changes in the distance between a needlelike probe and a conducting surface. Researchers apply a tiny voltage to the sample and move the probe -- a simple platinum-iridium wire snipped to end in a point just one atom wide -- just a few angstroms (tenths of a nanometer) over the sample's surface. By measuring changes in current as electrons tunnel between the sample and the probe, they can reconstruct a map of the surface topology down to the atomic level. Since its invention in the 1980s, the STM has enabled major discoveries in fields from semiconductor technology to nanoelectronics. But while current can change in a nanosecond, measurements with the STM are painfully slow. And the limiting factor is not in the signal itself: It's in the basic electronics involved in analyzing it. A theoretical STM could collect data as fast as electrons can tunnel -- at a rate of one gigahertz, or 1 billion cycles per second of bandwidth. But a typical STM is slowed down by the capacitance, or energy storage, in the cables that make up its readout circuitry -- to about one kilohertz (1000 cycles per second) or less. Researchers have tried a variety of complex remedies. But in the end, Schwab said, the solution was surprisingly simple. By adding an external source of radio frequency (RF) waves and sending a wave into the STM through a simple network, the researchers showed that it's possible to detect the resistance at the tunneling junction -- and hence the distance between the probe and sample surface -- based on the characteristics of the wave that reflects back to the source. The technique, called reflectometry, uses the standard cables as paths for high-frequency waves, which aren't slowed down by the cables' capacitance. "There are six orders of magnitude between the fundamental limit in frequency and where people are operating," said Schwab. With the RF adaptation, speeds increase by a factor of between 100 and 1000. "Our hope is that we can produce more or less video images, as opposed to a scan that takes forever. "This STM will be used for a lot of good physics experiments," said Schwab. "Once you open up this new parameter, all this bandwidth, people will figure out ways to use it. I firmly believe 10 years from now there will be a lot of RF-STMs around, and people will do all kinds of great experiments with them." The research, which was supported by the National Science Foundation, is described in the Nov. 1 issue of the journal Nature.For more information, visit: www.cornell.edu